Loading...
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 114 115 116 117 118 119 120 121 122 123 124 125 126 127 128 129 130 131 132 133 134 135 136 137 138 139 140 141 142 143 144 145 146 147 148 149 150 151 152 153 154 155 156 157 158 159 160 161 162 163 164 165 166 167 168 169 170 171 172 173 174 175 176 177 178 | // SPDX-License-Identifier: GPL-2.0+ // // Copyright (C) 2016-2018 Vladimir Zapolskiy <vz@mleia.com> /dts-v1/; #include "imx31.dtsi" #include <dt-bindings/gpio/gpio.h> #include <dt-bindings/interrupt-controller/irq.h> / { model = "LogicPD i.MX31 Lite"; compatible = "logicpd,imx31-lite", "fsl,imx31"; chosen { stdout-path = &uart1; }; memory@80000000 { device_type = "memory"; reg = <0x80000000 0x8000000>; }; leds { compatible = "gpio-leds"; led0 { gpios = <&gpio1 8 GPIO_ACTIVE_LOW>; }; led1 { gpios = <&gpio1 7 GPIO_ACTIVE_LOW>; }; }; }; &ata { status = "okay"; }; &nfc { nand-bus-width = <8>; nand-ecc-mode = "hw"; nand-on-flash-bbt; status = "okay"; }; &sdhci1 { bus-width = <4>; cd-gpios = <&gpio2 11 GPIO_ACTIVE_HIGH>; wp-gpios = <&gpio1 6 GPIO_ACTIVE_HIGH>; status = "okay"; }; &spi2 { status = "okay"; pmic@0 { compatible = "fsl,mc13783"; reg = <0>; spi-cs-high; spi-max-frequency = <1000000>; interrupt-parent = <&gpio1>; interrupts = <3 IRQ_TYPE_EDGE_RISING>; fsl,mc13xxx-uses-adc; fsl,mc13xxx-uses-rtc; regulators { sw1a { /* QVCC */ regulator-min-microvolt = <1200000>; regulator-max-microvolt = <1500000>; regulator-always-on; regulator-boot-on; }; sw1b { /* QVCC */ regulator-min-microvolt = <1200000>; regulator-max-microvolt = <1500000>; regulator-always-on; regulator-boot-on; }; sw2a { /* 1.8V_DDR, NVCC2, NVCC21 and NVCC22 */ regulator-min-microvolt = <1800000>; regulator-max-microvolt = <1800000>; regulator-always-on; regulator-boot-on; }; sw2b { /* NVCC10 */ regulator-min-microvolt = <1800000>; regulator-max-microvolt = <1800000>; regulator-always-on; regulator-boot-on; }; violo { /* NVCC1 and NVCC7 */ regulator-min-microvolt = <1800000>; regulator-max-microvolt = <1800000>; regulator-always-on; regulator-boot-on; }; viohi { /* VIOHI */ regulator-min-microvolt = <2775000>; regulator-max-microvolt = <2775000>; regulator-always-on; regulator-boot-on; }; vaudio { /* VAUDIO */ regulator-min-microvolt = <2775000>; regulator-max-microvolt = <2775000>; }; vcam { /* NVCC4 */ regulator-min-microvolt = <2800000>; regulator-max-microvolt = <2800000>; }; vgen { /* NVCC5 / NVCC8 and NVCC6 / NVCC9 */ regulator-min-microvolt = <2775000>; regulator-max-microvolt = <2775000>; regulator-always-on; regulator-boot-on; }; vmmc2 { /* NVCC3 */ regulator-min-microvolt = <1600000>; regulator-max-microvolt = <3000000>; regulator-always-on; regulator-boot-on; }; }; }; }; &uart1 { uart-has-rtscts; status = "okay"; }; /* Routed to the extension board */ &uart2 { uart-has-rtscts; status = "okay"; }; /* Routed to the extension board */ &uart3 { uart-has-rtscts; status = "okay"; }; &weim { status = "okay"; nor@0,0 { compatible = "cfi-flash"; reg = <0 0x0 0x200000>; bank-width = <2>; linux,mtd-name = "physmap-flash.0"; fsl,weim-cs-timing = <0x0000cf03 0xa0330d01 0x00220800>; }; ethernet@4,0 { compatible = "smsc,lan9117", "smsc,lan9115"; reg = <4 0x0 0x100>; interrupt-parent = <&gpio1>; interrupts = <26 IRQ_TYPE_EDGE_FALLING>; phy-mode = "mii"; reg-io-width = <2>; smsc,irq-push-pull; fsl,weim-cs-timing = <0x00008701 0x04000541 0x00010000>; }; }; |