Loading...
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 114 115 116 117 118 119 120 121 122 123 124 125 126 127 128 129 130 131 132 133 134 135 136 137 138 139 140 141 142 143 144 145 146 147 148 149 150 151 152 153 154 155 156 157 158 159 160 161 162 163 164 165 166 167 168 169 170 171 172 173 174 175 176 177 178 179 180 181 182 183 184 185 186 187 188 189 190 191 192 193 194 195 196 197 198 199 200 201 202 203 204 205 206 207 208 209 210 211 212 213 214 215 216 217 218 219 220 221 222 223 224 225 226 227 228 229 230 231 232 233 234 235 236 237 238 239 240 241 242 243 244 245 246 247 248 249 250 251 252 253 254 255 256 257 258 259 260 261 262 | // SPDX-License-Identifier: GPL-2.0-only /* * Dallas Semiconductor DS1682 Elapsed Time Recorder device driver * * Written by: Grant Likely <grant.likely@secretlab.ca> * * Copyright (C) 2007 Secret Lab Technologies Ltd. */ /* * The DS1682 elapsed timer recorder is a simple device that implements * one elapsed time counter, one event counter, an alarm signal and 10 * bytes of general purpose EEPROM. * * This driver provides access to the DS1682 counters and user data via * the sysfs. The following attributes are added to the device node: * elapsed_time (u32): Total elapsed event time in ms resolution * alarm_time (u32): When elapsed time exceeds the value in alarm_time, * then the alarm pin is asserted. * event_count (u16): number of times the event pin has gone low. * eeprom (u8[10]): general purpose EEPROM * * Counter registers and user data are both read/write unless the device * has been write protected. This driver does not support turning off write * protection. Once write protection is turned on, it is impossible to * turn it off again, so I have left the feature out of this driver to avoid * accidental enabling, but it is trivial to add write protect support. * */ #include <linux/module.h> #include <linux/i2c.h> #include <linux/string.h> #include <linux/list.h> #include <linux/sysfs.h> #include <linux/ctype.h> #include <linux/hwmon-sysfs.h> /* Device registers */ #define DS1682_REG_CONFIG 0x00 #define DS1682_REG_ALARM 0x01 #define DS1682_REG_ELAPSED 0x05 #define DS1682_REG_EVT_CNTR 0x09 #define DS1682_REG_EEPROM 0x0b #define DS1682_REG_RESET 0x1d #define DS1682_REG_WRITE_DISABLE 0x1e #define DS1682_REG_WRITE_MEM_DISABLE 0x1f #define DS1682_EEPROM_SIZE 10 /* * Generic counter attributes */ static ssize_t ds1682_show(struct device *dev, struct device_attribute *attr, char *buf) { struct sensor_device_attribute_2 *sattr = to_sensor_dev_attr_2(attr); struct i2c_client *client = to_i2c_client(dev); unsigned long long val, check; __le32 val_le = 0; int rc; dev_dbg(dev, "ds1682_show() called on %s\n", attr->attr.name); /* Read the register */ rc = i2c_smbus_read_i2c_block_data(client, sattr->index, sattr->nr, (u8 *)&val_le); if (rc < 0) return -EIO; val = le32_to_cpu(val_le); if (sattr->index == DS1682_REG_ELAPSED) { int retries = 5; /* Detect and retry when a tick occurs mid-read */ do { rc = i2c_smbus_read_i2c_block_data(client, sattr->index, sattr->nr, (u8 *)&val_le); if (rc < 0 || retries <= 0) return -EIO; check = val; val = le32_to_cpu(val_le); retries--; } while (val != check && val != (check + 1)); } /* Format the output string and return # of bytes * Special case: the 32 bit regs are time values with 1/4s * resolution, scale them up to milliseconds */ return sprintf(buf, "%llu\n", (sattr->nr == 4) ? (val * 250) : val); } static ssize_t ds1682_store(struct device *dev, struct device_attribute *attr, const char *buf, size_t count) { struct sensor_device_attribute_2 *sattr = to_sensor_dev_attr_2(attr); struct i2c_client *client = to_i2c_client(dev); u64 val; __le32 val_le; int rc; dev_dbg(dev, "ds1682_store() called on %s\n", attr->attr.name); /* Decode input */ rc = kstrtoull(buf, 0, &val); if (rc < 0) { dev_dbg(dev, "input string not a number\n"); return -EINVAL; } /* Special case: the 32 bit regs are time values with 1/4s * resolution, scale input down to quarter-seconds */ if (sattr->nr == 4) do_div(val, 250); /* write out the value */ val_le = cpu_to_le32(val); rc = i2c_smbus_write_i2c_block_data(client, sattr->index, sattr->nr, (u8 *) & val_le); if (rc < 0) { dev_err(dev, "register write failed; reg=0x%x, size=%i\n", sattr->index, sattr->nr); return -EIO; } return count; } /* * Simple register attributes */ static SENSOR_DEVICE_ATTR_2(elapsed_time, S_IRUGO | S_IWUSR, ds1682_show, ds1682_store, 4, DS1682_REG_ELAPSED); static SENSOR_DEVICE_ATTR_2(alarm_time, S_IRUGO | S_IWUSR, ds1682_show, ds1682_store, 4, DS1682_REG_ALARM); static SENSOR_DEVICE_ATTR_2(event_count, S_IRUGO | S_IWUSR, ds1682_show, ds1682_store, 2, DS1682_REG_EVT_CNTR); static const struct attribute_group ds1682_group = { .attrs = (struct attribute *[]) { &sensor_dev_attr_elapsed_time.dev_attr.attr, &sensor_dev_attr_alarm_time.dev_attr.attr, &sensor_dev_attr_event_count.dev_attr.attr, NULL, }, }; /* * User data attribute */ static ssize_t ds1682_eeprom_read(struct file *filp, struct kobject *kobj, struct bin_attribute *attr, char *buf, loff_t off, size_t count) { struct i2c_client *client = kobj_to_i2c_client(kobj); int rc; dev_dbg(&client->dev, "ds1682_eeprom_read(p=%p, off=%lli, c=%zi)\n", buf, off, count); rc = i2c_smbus_read_i2c_block_data(client, DS1682_REG_EEPROM + off, count, buf); if (rc < 0) return -EIO; return count; } static ssize_t ds1682_eeprom_write(struct file *filp, struct kobject *kobj, struct bin_attribute *attr, char *buf, loff_t off, size_t count) { struct i2c_client *client = kobj_to_i2c_client(kobj); dev_dbg(&client->dev, "ds1682_eeprom_write(p=%p, off=%lli, c=%zi)\n", buf, off, count); /* Write out to the device */ if (i2c_smbus_write_i2c_block_data(client, DS1682_REG_EEPROM + off, count, buf) < 0) return -EIO; return count; } static const struct bin_attribute ds1682_eeprom_attr = { .attr = { .name = "eeprom", .mode = S_IRUGO | S_IWUSR, }, .size = DS1682_EEPROM_SIZE, .read = ds1682_eeprom_read, .write = ds1682_eeprom_write, }; /* * Called when a ds1682 device is matched with this driver */ static int ds1682_probe(struct i2c_client *client) { int rc; if (!i2c_check_functionality(client->adapter, I2C_FUNC_SMBUS_I2C_BLOCK)) { dev_err(&client->dev, "i2c bus does not support the ds1682\n"); rc = -ENODEV; goto exit; } rc = sysfs_create_group(&client->dev.kobj, &ds1682_group); if (rc) goto exit; rc = sysfs_create_bin_file(&client->dev.kobj, &ds1682_eeprom_attr); if (rc) goto exit_bin_attr; return 0; exit_bin_attr: sysfs_remove_group(&client->dev.kobj, &ds1682_group); exit: return rc; } static void ds1682_remove(struct i2c_client *client) { sysfs_remove_bin_file(&client->dev.kobj, &ds1682_eeprom_attr); sysfs_remove_group(&client->dev.kobj, &ds1682_group); } static const struct i2c_device_id ds1682_id[] = { { "ds1682", 0 }, { } }; MODULE_DEVICE_TABLE(i2c, ds1682_id); static const struct of_device_id ds1682_of_match[] = { { .compatible = "dallas,ds1682", }, {} }; MODULE_DEVICE_TABLE(of, ds1682_of_match); static struct i2c_driver ds1682_driver = { .driver = { .name = "ds1682", .of_match_table = ds1682_of_match, }, .probe = ds1682_probe, .remove = ds1682_remove, .id_table = ds1682_id, }; module_i2c_driver(ds1682_driver); MODULE_AUTHOR("Grant Likely <grant.likely@secretlab.ca>"); MODULE_DESCRIPTION("DS1682 Elapsed Time Indicator driver"); MODULE_LICENSE("GPL"); |