Linux Audio

Check our new training course

Embedded Linux Audio

Check our new training course
with Creative Commons CC-BY-SA
lecture materials

Bootlin logo

Elixir Cross Referencer

Loading...
Qualcomm's APQ8016/MSM8916 USB transceiver controller

- compatible:
    Usage: required
    Value type: <string>
    Definition: Should contain "qcom,usb-8x16-phy".

- reg:
    Usage: required
    Value type: <prop-encoded-array>
    Definition: USB PHY base address and length of the register map

- clocks:
    Usage: required
    Value type: <prop-encoded-array>
    Definition: See clock-bindings.txt section "consumers". List of
                two clock specifiers for interface and core controller
                clocks.

- clock-names:
    Usage: required
    Value type: <string>
    Definition: Must contain "iface" and "core" strings.

- vddcx-supply:
    Usage: required
    Value type: <phandle>
    Definition: phandle to the regulator VDCCX supply node.

- v1p8-supply:
    Usage: required
    Value type: <phandle>
    Definition: phandle to the regulator 1.8V supply node.

- v3p3-supply:
    Usage: required
    Value type: <phandle>
    Definition: phandle to the regulator 3.3V supply node.

- resets:
    Usage: required
    Value type: <prop-encoded-array>
    Definition: See reset.txt section "consumers". PHY reset specifier.

- reset-names:
    Usage: required
    Value type: <string>
    Definition: Must contain "phy" string.

- switch-gpio:
    Usage: optional
    Value type: <prop-encoded-array>
    Definition: Some boards are using Dual SPDT USB Switch, witch is
                controlled by GPIO to de/multiplex D+/D- USB lines
                between connectors.

Example:
	usb_phy: phy@78d9000 {
		compatible = "qcom,usb-8x16-phy";
		reg = <0x78d9000 0x400>;

		vddcx-supply = <&pm8916_s1_corner>;
		v1p8-supply = <&pm8916_l7>;
		v3p3-supply = <&pm8916_l13>;

		clocks = <&gcc GCC_USB_HS_AHB_CLK>,
			     <&gcc GCC_USB_HS_SYSTEM_CLK>;
		clock-names = "iface", "core";

		resets = <&gcc GCC_USB2A_PHY_BCR>;
		reset-names = "phy";

		// D+/D- lines: 1 - Routed to HUB, 0 - Device connector
		switch-gpio = <&pm8916_gpios 4 GPIO_ACTIVE_HIGH>;
	};