// SPDX-License-Identifier: GPL-2.0-or-later
/*
* ADIS16201 Dual-Axis Digital Inclinometer and Accelerometer
*
* Copyright 2010 Analog Devices Inc.
*/
#include <linux/device.h>
#include <linux/kernel.h>
#include <linux/module.h>
#include <linux/spi/spi.h>
#include <linux/iio/iio.h>
#include <linux/iio/imu/adis.h>
#define ADIS16201_STARTUP_DELAY_MS 220
#define ADIS16201_FLASH_CNT 0x00
/* Data Output Register Information */
#define ADIS16201_SUPPLY_OUT_REG 0x02
#define ADIS16201_XACCL_OUT_REG 0x04
#define ADIS16201_YACCL_OUT_REG 0x06
#define ADIS16201_AUX_ADC_REG 0x08
#define ADIS16201_TEMP_OUT_REG 0x0A
#define ADIS16201_XINCL_OUT_REG 0x0C
#define ADIS16201_YINCL_OUT_REG 0x0E
/* Calibration Register Definition */
#define ADIS16201_XACCL_OFFS_REG 0x10
#define ADIS16201_YACCL_OFFS_REG 0x12
#define ADIS16201_XACCL_SCALE_REG 0x14
#define ADIS16201_YACCL_SCALE_REG 0x16
#define ADIS16201_XINCL_OFFS_REG 0x18
#define ADIS16201_YINCL_OFFS_REG 0x1A
#define ADIS16201_XINCL_SCALE_REG 0x1C
#define ADIS16201_YINCL_SCALE_REG 0x1E
/* Alarm Register Definition */
#define ADIS16201_ALM_MAG1_REG 0x20
#define ADIS16201_ALM_MAG2_REG 0x22
#define ADIS16201_ALM_SMPL1_REG 0x24
#define ADIS16201_ALM_SMPL2_REG 0x26
#define ADIS16201_ALM_CTRL_REG 0x28
#define ADIS16201_AUX_DAC_REG 0x30
#define ADIS16201_GPIO_CTRL_REG 0x32
#define ADIS16201_SMPL_PRD_REG 0x36
/* Operation, filter configuration */
#define ADIS16201_AVG_CNT_REG 0x38
#define ADIS16201_SLP_CNT_REG 0x3A
/* Miscellaneous Control Register Definition */
#define ADIS16201_MSC_CTRL_REG 0x34
#define ADIS16201_MSC_CTRL_SELF_TEST_EN BIT(8)
/* Data-ready enable: 1 = enabled, 0 = disabled */
#define ADIS16201_MSC_CTRL_DATA_RDY_EN BIT(2)
/* Data-ready polarity: 1 = active high, 0 = active low */
#define ADIS16201_MSC_CTRL_ACTIVE_DATA_RDY_HIGH BIT(1)
/* Data-ready line selection: 1 = DIO1, 0 = DIO0 */
#define ADIS16201_MSC_CTRL_DATA_RDY_DIO1 BIT(0)
/* Diagnostics System Status Register Definition */
#define ADIS16201_DIAG_STAT_REG 0x3C
#define ADIS16201_DIAG_STAT_ALARM2 BIT(9)
#define ADIS16201_DIAG_STAT_ALARM1 BIT(8)
#define ADIS16201_DIAG_STAT_SPI_FAIL_BIT 3
#define ADIS16201_DIAG_STAT_FLASH_UPT_FAIL_BIT 2
/* Power supply above 3.625 V */
#define ADIS16201_DIAG_STAT_POWER_HIGH_BIT 1
/* Power supply below 2.975 V */
#define ADIS16201_DIAG_STAT_POWER_LOW_BIT 0
/* System Command Register Definition */
#define ADIS16201_GLOB_CMD_REG 0x3E
#define ADIS16201_GLOB_CMD_SW_RESET BIT(7)
#define ADIS16201_GLOB_CMD_FACTORY_RESET BIT(1)
#define ADIS16201_ERROR_ACTIVE BIT(14)
enum adis16201_scan {
ADIS16201_SCAN_ACC_X,
ADIS16201_SCAN_ACC_Y,
ADIS16201_SCAN_INCLI_X,
ADIS16201_SCAN_INCLI_Y,
ADIS16201_SCAN_SUPPLY,
ADIS16201_SCAN_AUX_ADC,
ADIS16201_SCAN_TEMP,
};
static const u8 adis16201_addresses[] = {
[ADIS16201_SCAN_ACC_X] = ADIS16201_XACCL_OFFS_REG,
[ADIS16201_SCAN_ACC_Y] = ADIS16201_YACCL_OFFS_REG,
[ADIS16201_SCAN_INCLI_X] = ADIS16201_XINCL_OFFS_REG,
[ADIS16201_SCAN_INCLI_Y] = ADIS16201_YINCL_OFFS_REG,
};
static int adis16201_read_raw(struct iio_dev *indio_dev,
struct iio_chan_spec const *chan,
int *val, int *val2,
long mask)
{
struct adis *st = iio_priv(indio_dev);
int ret;
int bits;
u8 addr;
s16 val16;
switch (mask) {
case IIO_CHAN_INFO_RAW:
return adis_single_conversion(indio_dev, chan,
ADIS16201_ERROR_ACTIVE, val);
case IIO_CHAN_INFO_SCALE:
switch (chan->type) {
case IIO_VOLTAGE:
if (chan->channel == 0) {
/* Voltage base units are mV hence 1.22 mV */
*val = 1;
*val2 = 220000;
} else {
/* Voltage base units are mV hence 0.61 mV */
*val = 0;
*val2 = 610000;
}
return IIO_VAL_INT_PLUS_MICRO;
case IIO_TEMP:
*val = -470;
*val2 = 0;
return IIO_VAL_INT_PLUS_MICRO;
case IIO_ACCEL:
/*
* IIO base unit for sensitivity of accelerometer
* is milli g.
* 1 LSB represents 0.244 mg.
*/
*val = 0;
*val2 = IIO_G_TO_M_S_2(462400);
return IIO_VAL_INT_PLUS_NANO;
case IIO_INCLI:
*val = 0;
*val2 = 100000;
return IIO_VAL_INT_PLUS_MICRO;
default:
return -EINVAL;
}
break;
case IIO_CHAN_INFO_OFFSET:
/*
* The raw ADC value is 1278 when the temperature
* is 25 degrees and the scale factor per milli
* degree celcius is -470.
*/
*val = 25000 / -470 - 1278;
return IIO_VAL_INT;
case IIO_CHAN_INFO_CALIBBIAS:
switch (chan->type) {
case IIO_ACCEL:
bits = 12;
break;
case IIO_INCLI:
bits = 9;
break;
default:
return -EINVAL;
}
addr = adis16201_addresses[chan->scan_index];
ret = adis_read_reg_16(st, addr, &val16);
if (ret)
return ret;
*val = sign_extend32(val16, bits - 1);
return IIO_VAL_INT;
}
return -EINVAL;
}
static int adis16201_write_raw(struct iio_dev *indio_dev,
struct iio_chan_spec const *chan,
int val,
int val2,
long mask)
{
struct adis *st = iio_priv(indio_dev);
int m;
if (mask != IIO_CHAN_INFO_CALIBBIAS)
return -EINVAL;
switch (chan->type) {
case IIO_ACCEL:
m = GENMASK(11, 0);
break;
case IIO_INCLI:
m = GENMASK(8, 0);
break;
default:
return -EINVAL;
}
return adis_write_reg_16(st, adis16201_addresses[chan->scan_index],
val & m);
}
static const struct iio_chan_spec adis16201_channels[] = {
ADIS_SUPPLY_CHAN(ADIS16201_SUPPLY_OUT_REG, ADIS16201_SCAN_SUPPLY, 0,
12),
ADIS_TEMP_CHAN(ADIS16201_TEMP_OUT_REG, ADIS16201_SCAN_TEMP, 0, 12),
ADIS_ACCEL_CHAN(X, ADIS16201_XACCL_OUT_REG, ADIS16201_SCAN_ACC_X,
BIT(IIO_CHAN_INFO_CALIBBIAS), 0, 14),
ADIS_ACCEL_CHAN(Y, ADIS16201_YACCL_OUT_REG, ADIS16201_SCAN_ACC_Y,
BIT(IIO_CHAN_INFO_CALIBBIAS), 0, 14),
ADIS_AUX_ADC_CHAN(ADIS16201_AUX_ADC_REG, ADIS16201_SCAN_AUX_ADC, 0, 12),
ADIS_INCLI_CHAN(X, ADIS16201_XINCL_OUT_REG, ADIS16201_SCAN_INCLI_X,
BIT(IIO_CHAN_INFO_CALIBBIAS), 0, 14),
ADIS_INCLI_CHAN(Y, ADIS16201_YINCL_OUT_REG, ADIS16201_SCAN_INCLI_Y,
BIT(IIO_CHAN_INFO_CALIBBIAS), 0, 14),
IIO_CHAN_SOFT_TIMESTAMP(7)
};
static const struct iio_info adis16201_info = {
.read_raw = adis16201_read_raw,
.write_raw = adis16201_write_raw,
.update_scan_mode = adis_update_scan_mode,
};
static const char * const adis16201_status_error_msgs[] = {
[ADIS16201_DIAG_STAT_SPI_FAIL_BIT] = "SPI failure",
[ADIS16201_DIAG_STAT_FLASH_UPT_FAIL_BIT] = "Flash update failed",
[ADIS16201_DIAG_STAT_POWER_HIGH_BIT] = "Power supply above 3.625V",
[ADIS16201_DIAG_STAT_POWER_LOW_BIT] = "Power supply below 2.975V",
};
static const struct adis_timeout adis16201_timeouts = {
.reset_ms = ADIS16201_STARTUP_DELAY_MS,
.sw_reset_ms = ADIS16201_STARTUP_DELAY_MS,
.self_test_ms = ADIS16201_STARTUP_DELAY_MS,
};
static const struct adis_data adis16201_data = {
.read_delay = 20,
.msc_ctrl_reg = ADIS16201_MSC_CTRL_REG,
.glob_cmd_reg = ADIS16201_GLOB_CMD_REG,
.diag_stat_reg = ADIS16201_DIAG_STAT_REG,
.self_test_mask = ADIS16201_MSC_CTRL_SELF_TEST_EN,
.self_test_reg = ADIS16201_MSC_CTRL_REG,
.self_test_no_autoclear = true,
.timeouts = &adis16201_timeouts,
.status_error_msgs = adis16201_status_error_msgs,
.status_error_mask = BIT(ADIS16201_DIAG_STAT_SPI_FAIL_BIT) |
BIT(ADIS16201_DIAG_STAT_FLASH_UPT_FAIL_BIT) |
BIT(ADIS16201_DIAG_STAT_POWER_HIGH_BIT) |
BIT(ADIS16201_DIAG_STAT_POWER_LOW_BIT),
};
static int adis16201_probe(struct spi_device *spi)
{
struct iio_dev *indio_dev;
struct adis *st;
int ret;
indio_dev = devm_iio_device_alloc(&spi->dev, sizeof(*st));
if (!indio_dev)
return -ENOMEM;
st = iio_priv(indio_dev);
indio_dev->name = spi->dev.driver->name;
indio_dev->info = &adis16201_info;
indio_dev->channels = adis16201_channels;
indio_dev->num_channels = ARRAY_SIZE(adis16201_channels);
indio_dev->modes = INDIO_DIRECT_MODE;
ret = adis_init(st, indio_dev, spi, &adis16201_data);
if (ret)
return ret;
ret = devm_adis_setup_buffer_and_trigger(st, indio_dev, NULL);
if (ret)
return ret;
ret = __adis_initial_startup(st);
if (ret)
return ret;
return devm_iio_device_register(&spi->dev, indio_dev);
}
static struct spi_driver adis16201_driver = {
.driver = {
.name = "adis16201",
},
.probe = adis16201_probe,
};
module_spi_driver(adis16201_driver);
MODULE_AUTHOR("Barry Song <21cnbao@gmail.com>");
MODULE_DESCRIPTION("Analog Devices ADIS16201 Dual-Axis Digital Inclinometer and Accelerometer");
MODULE_LICENSE("GPL v2");
MODULE_ALIAS("spi:adis16201");
MODULE_IMPORT_NS(IIO_ADISLIB);
