Loading...
Kernel drivers ltc2947-i2c and ltc2947-spi ========================================== Supported chips: * Analog Devices LTC2947 Prefix: 'ltc2947' Addresses scanned: - Datasheet: https://www.analog.com/media/en/technical-documentation/data-sheets/LTC2947.pdf Author: Nuno Sá <nuno.sa@analog.com> Description ___________ The LTC2947 is a high precision power and energy monitor that measures current, voltage, power, temperature, charge and energy. The device supports both SPI and I2C depending on the chip configuration. The device also measures accumulated quantities as energy. It has two banks of register's to read/set energy related values. These banks can be configured independently to have setups like: energy1 accumulates always and enrgy2 only accumulates if current is positive (to check battery charging efficiency for example). The device also supports a GPIO pin that can be configured as output to control a fan as a function of measured temperature. Then, the GPIO becomes active as soon as a temperature reading is higher than a defined threshold. The temp2 channel is used to control this thresholds and to read the respective alarms. Sysfs entries _____________ The following attributes are supported. Limits are read-write, reset_history is write-only and all the other attributes are read-only. ======================= ========================================== in0_input VP-VM voltage (mV). in0_min Undervoltage threshold in0_max Overvoltage threshold in0_lowest Lowest measured voltage in0_highest Highest measured voltage in0_reset_history Write 1 to reset in1 history in0_min_alarm Undervoltage alarm in0_max_alarm Overvoltage alarm in0_label Channel label (VP-VM) in1_input DVCC voltage (mV) in1_min Undervoltage threshold in1_max Overvoltage threshold in1_lowest Lowest measured voltage in1_highest Highest measured voltage in1_reset_history Write 1 to reset in2 history in1_min_alarm Undervoltage alarm in1_max_alarm Overvoltage alarm in1_label Channel label (DVCC) curr1_input IP-IM Sense current (mA) curr1_min Undercurrent threshold curr1_max Overcurrent threshold curr1_lowest Lowest measured current curr1_highest Highest measured current curr1_reset_history Write 1 to reset curr1 history curr1_min_alarm Undercurrent alarm curr1_max_alarm Overcurrent alarm curr1_label Channel label (IP-IM) power1_input Power (in uW) power1_min Low power threshold power1_max High power threshold power1_input_lowest Historical minimum power use power1_input_highest Historical maximum power use power1_reset_history Write 1 to reset power1 history power1_min_alarm Low power alarm power1_max_alarm High power alarm power1_label Channel label (Power) temp1_input Chip Temperature (in milliC) temp1_min Low temperature threshold temp1_max High temperature threshold temp1_input_lowest Historical minimum temperature use temp1_input_highest Historical maximum temperature use temp1_reset_history Write 1 to reset temp1 history temp1_min_alarm Low temperature alarm temp1_max_alarm High temperature alarm temp1_label Channel label (Ambient) temp2_min Low temperature threshold for fan control temp2_max High temperature threshold for fan control temp2_min_alarm Low temperature fan control alarm temp2_max_alarm High temperature fan control alarm temp2_label Channel label (TEMPFAN) energy1_input Measured energy over time (in microJoule) energy2_input Measured energy over time (in microJoule) ======================= ========================================== |