Loading...
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 114 115 116 117 118 119 120 121 122 123 124 125 126 127 128 129 130 131 132 133 134 135 136 137 138 139 140 141 142 143 144 145 146 147 148 149 150 151 152 153 154 155 156 157 | /* * Support for CompuLab CM-T3517 */ /dts-v1/; #include "am3517.dtsi" #include "omap3-cm-t3x.dtsi" / { model = "CompuLab CM-T3517"; compatible = "compulab,omap3-cm-t3517", "ti,am3517", "ti,omap3"; vmmc: regulator-vmmc { compatible = "regulator-fixed"; regulator-name = "vmmc"; regulator-min-microvolt = <3300000>; regulator-max-microvolt = <3300000>; }; wl12xx_vmmc2: wl12xx_vmmc2 { compatible = "regulator-fixed"; regulator-name = "vw1271"; pinctrl-names = "default"; pinctrl-0 = < &wl12xx_wkup_pins &wl12xx_core_pins >; regulator-min-microvolt = <1800000>; regulator-max-microvolt = <1800000>; gpio = <&gpio1 6 GPIO_ACTIVE_HIGH >; /* gpio6 */ startup-delay-us = <20000>; enable-active-high; }; wl12xx_vaux2: wl12xx_vaux2 { compatible = "regulator-fixed"; regulator-name = "vwl1271_vaux2"; regulator-min-microvolt = <1800000>; regulator-max-microvolt = <1800000>; }; }; &omap3_pmx_wkup { wl12xx_wkup_pins: pinmux_wl12xx_wkup_pins { pinctrl-single,pins = < OMAP3_WKUP_IOPAD(0x2a0e, PIN_OUTPUT | MUX_MODE4) /* sys_boot2.gpio_4 */ OMAP3_WKUP_IOPAD(0x2a12, PIN_OUTPUT | MUX_MODE4) /* sys_boot4.gpio_6 */ >; }; }; &omap3_pmx_core { phy1_reset_pins: pinmux_hsusb1_phy_reset_pins { pinctrl-single,pins = < OMAP3_CORE1_IOPAD(0x2178, PIN_OUTPUT | MUX_MODE4) /* uart2_tx.gpio_146 */ >; }; phy2_reset_pins: pinmux_hsusb2_phy_reset_pins { pinctrl-single,pins = < OMAP3_CORE1_IOPAD(0x217a, PIN_OUTPUT | MUX_MODE4) /* uart2_rx.gpio_147 */ >; }; otg_drv_vbus: pinmux_otg_drv_vbus { pinctrl-single,pins = < OMAP3_CORE1_IOPAD(0x2210, PIN_INPUT_PULLDOWN | MUX_MODE0) /* rmii_50MHz_clk.usb0_drvvbus */ >; }; mmc2_pins: pinmux_mmc2_pins { pinctrl-single,pins = < OMAP3_CORE1_IOPAD(0x2158, PIN_INPUT_PULLUP | MUX_MODE0) /* sdmmc2_clk.sdmmc2_clk */ OMAP3_CORE1_IOPAD(0x215a, PIN_INPUT_PULLUP | MUX_MODE0) /* sdmmc2_cmd.sdmmc2_cmd */ OMAP3_CORE1_IOPAD(0x215c, PIN_INPUT_PULLUP | MUX_MODE0) /* sdmmc2_dat0.sdmmc2_dat0 */ OMAP3_CORE1_IOPAD(0x215e, PIN_INPUT_PULLUP | MUX_MODE0) /* sdmmc2_dat1.sdmmc2_dat1 */ OMAP3_CORE1_IOPAD(0x2160, PIN_INPUT_PULLUP | MUX_MODE0) /* sdmmc2_dat2.sdmmc2_dat2 */ OMAP3_CORE1_IOPAD(0x2162, PIN_INPUT_PULLUP | MUX_MODE0) /* sdmmc2_dat3.sdmmc2_dat3 */ >; }; wl12xx_core_pins: pinmux_wl12xx_core_pins { pinctrl-single,pins = < OMAP3_CORE1_IOPAD(0x20b8, PIN_OUTPUT | MUX_MODE4) /* gpmc_ncs5.gpio_56 */ OMAP3_CORE1_IOPAD(0x2176, PIN_INPUT_PULLUP | MUX_MODE4) /* uart2_rts.gpio_145 */ >; }; usb_hub_pins: pinmux_usb_hub_pins { pinctrl-single,pins = < OMAP3_CORE1_IOPAD(0x2184, PIN_OUTPUT | MUX_MODE4) /* mcbsp4_clkx.gpio_152 - USB HUB RST */ >; }; }; &hsusb1_phy { pinctrl-names = "default"; pinctrl-0 = <&phy1_reset_pins>; reset-gpios = <&gpio5 18 GPIO_ACTIVE_LOW>; }; &hsusb2_phy { pinctrl-names = "default"; pinctrl-0 = <&phy2_reset_pins>; reset-gpios = <&gpio5 19 GPIO_ACTIVE_LOW>; }; &davinci_emac { status = "okay"; }; &davinci_mdio { status = "okay"; }; &am35x_otg_hs { status = "okay"; pinctrl-names = "default"; pinctrl-0 = <&otg_drv_vbus>; }; &mmc1 { vmmc-supply = <&vmmc>; }; &mmc2 { pinctrl-names = "default"; pinctrl-0 = <&mmc2_pins>; vmmc-supply = <&wl12xx_vmmc2>; vmmc_aux-supply = <&wl12xx_vaux2>; non-removable; bus-width = <4>; cap-power-off-card; #address-cells = <1>; #size-cells = <0>; wlcore: wlcore@2 { compatible = "ti,wl1271"; reg = <2>; interrupt-parent = <&gpio5>; interrupts = <17 IRQ_TYPE_LEVEL_HIGH>; /* gpio 145 */ ref-clock-frequency = <38400000>; }; }; &dss { status = "ok"; pinctrl-names = "default"; pinctrl-0 = < &dss_dpi_pins_common &dss_dpi_pins_cm_t35x >; }; |