Loading...
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 114 115 116 117 118 119 120 121 122 123 124 125 126 127 128 129 130 131 132 133 134 135 136 137 138 139 140 141 142 143 144 145 146 147 148 149 150 151 152 153 154 155 156 157 158 159 160 161 162 163 164 165 166 167 168 169 170 171 | /* SPDX-License-Identifier: GPL-2.0 */ #ifndef DDK750_SII164_H__ #define DDK750_SII164_H__ #define USE_DVICHIP /* Hot Plug detection mode structure */ enum sii164_hot_plug_mode { SII164_HOTPLUG_DISABLE = 0, /* Disable Hot Plug output bit (always high). */ SII164_HOTPLUG_USE_MDI, /* Use Monitor Detect Interrupt bit. */ SII164_HOTPLUG_USE_RSEN, /* Use Receiver Sense detect bit. */ SII164_HOTPLUG_USE_HTPLG /* Use Hot Plug detect bit. */ }; /* Silicon Image SiI164 chip prototype */ long sii164InitChip(unsigned char edgeSelect, unsigned char busSelect, unsigned char dualEdgeClkSelect, unsigned char hsyncEnable, unsigned char vsyncEnable, unsigned char deskewEnable, unsigned char deskewSetting, unsigned char continuousSyncEnable, unsigned char pllFilterEnable, unsigned char pllFilterValue); unsigned short sii164GetVendorID(void); unsigned short sii164GetDeviceID(void); #ifdef SII164_FULL_FUNCTIONS void sii164ResetChip(void); char *sii164GetChipString(void); void sii164SetPower(unsigned char powerUp); void sii164EnableHotPlugDetection(unsigned char enableHotPlug); unsigned char sii164IsConnected(void); unsigned char sii164CheckInterrupt(void); void sii164ClearInterrupt(void); #endif /* * below register definition is used for * Silicon Image SiI164 DVI controller chip */ /* * Vendor ID registers */ #define SII164_VENDOR_ID_LOW 0x00 #define SII164_VENDOR_ID_HIGH 0x01 /* * Device ID registers */ #define SII164_DEVICE_ID_LOW 0x02 #define SII164_DEVICE_ID_HIGH 0x03 /* * Device Revision */ #define SII164_DEVICE_REVISION 0x04 /* * Frequency Limitation registers */ #define SII164_FREQUENCY_LIMIT_LOW 0x06 #define SII164_FREQUENCY_LIMIT_HIGH 0x07 /* * Power Down and Input Signal Configuration registers */ #define SII164_CONFIGURATION 0x08 /* Power down (PD) */ #define SII164_CONFIGURATION_POWER_DOWN 0x00 #define SII164_CONFIGURATION_POWER_NORMAL 0x01 #define SII164_CONFIGURATION_POWER_MASK 0x01 /* Input Edge Latch Select (EDGE) */ #define SII164_CONFIGURATION_LATCH_FALLING 0x00 #define SII164_CONFIGURATION_LATCH_RISING 0x02 /* Bus Select (BSEL) */ #define SII164_CONFIGURATION_BUS_12BITS 0x00 #define SII164_CONFIGURATION_BUS_24BITS 0x04 /* Dual Edge Clock Select (DSEL) */ #define SII164_CONFIGURATION_CLOCK_SINGLE 0x00 #define SII164_CONFIGURATION_CLOCK_DUAL 0x08 /* Horizontal Sync Enable (HEN) */ #define SII164_CONFIGURATION_HSYNC_FORCE_LOW 0x00 #define SII164_CONFIGURATION_HSYNC_AS_IS 0x10 /* Vertical Sync Enable (VEN) */ #define SII164_CONFIGURATION_VSYNC_FORCE_LOW 0x00 #define SII164_CONFIGURATION_VSYNC_AS_IS 0x20 /* * Detection registers */ #define SII164_DETECT 0x09 /* Monitor Detect Interrupt (MDI) */ #define SII164_DETECT_MONITOR_STATE_CHANGE 0x00 #define SII164_DETECT_MONITOR_STATE_NO_CHANGE 0x01 #define SII164_DETECT_MONITOR_STATE_CLEAR 0x01 #define SII164_DETECT_MONITOR_STATE_MASK 0x01 /* Hot Plug detect Input (HTPLG) */ #define SII164_DETECT_HOT_PLUG_STATUS_OFF 0x00 #define SII164_DETECT_HOT_PLUG_STATUS_ON 0x02 #define SII164_DETECT_HOT_PLUG_STATUS_MASK 0x02 /* Receiver Sense (RSEN) */ #define SII164_DETECT_RECEIVER_SENSE_NOT_DETECTED 0x00 #define SII164_DETECT_RECEIVER_SENSE_DETECTED 0x04 /* Interrupt Generation Method (TSEL) */ #define SII164_DETECT_INTERRUPT_BY_RSEN_PIN 0x00 #define SII164_DETECT_INTERRUPT_BY_HTPLG_PIN 0x08 #define SII164_DETECT_INTERRUPT_MASK 0x08 /* Monitor Sense Output (MSEN) */ #define SII164_DETECT_MONITOR_SENSE_OUTPUT_HIGH 0x00 #define SII164_DETECT_MONITOR_SENSE_OUTPUT_MDI 0x10 #define SII164_DETECT_MONITOR_SENSE_OUTPUT_RSEN 0x20 #define SII164_DETECT_MONITOR_SENSE_OUTPUT_HTPLG 0x30 #define SII164_DETECT_MONITOR_SENSE_OUTPUT_FLAG 0x30 /* * Skewing registers */ #define SII164_DESKEW 0x0A /* General Purpose Input (CTL[3:1]) */ #define SII164_DESKEW_GENERAL_PURPOSE_INPUT_MASK 0x0E /* De-skewing Enable bit (DKEN) */ #define SII164_DESKEW_DISABLE 0x00 #define SII164_DESKEW_ENABLE 0x10 /* De-skewing Setting (DK[3:1])*/ #define SII164_DESKEW_1_STEP 0x00 #define SII164_DESKEW_2_STEP 0x20 #define SII164_DESKEW_3_STEP 0x40 #define SII164_DESKEW_4_STEP 0x60 #define SII164_DESKEW_5_STEP 0x80 #define SII164_DESKEW_6_STEP 0xA0 #define SII164_DESKEW_7_STEP 0xC0 #define SII164_DESKEW_8_STEP 0xE0 /* * User Configuration Data registers (CFG 7:0) */ #define SII164_USER_CONFIGURATION 0x0B /* * PLL registers */ #define SII164_PLL 0x0C /* PLL Filter Value (PLLF) */ #define SII164_PLL_FILTER_VALUE_MASK 0x0E /* PLL Filter Enable (PFEN) */ #define SII164_PLL_FILTER_DISABLE 0x00 #define SII164_PLL_FILTER_ENABLE 0x01 /* Sync Continuous (SCNT) */ #define SII164_PLL_FILTER_SYNC_CONTINUOUS_DISABLE 0x00 #define SII164_PLL_FILTER_SYNC_CONTINUOUS_ENABLE 0x80 #endif |