Broadcom BCM2835 CPRMAN clocks

This binding uses the common clock binding:
    Documentation/devicetree/bindings/clock/clock-bindings.txt

The CPRMAN clock controller generates clocks in the audio power domain
of the BCM2835.  There is a level of PLLs deriving from an external
oscillator, a level of PLL dividers that produce channels off of the
few PLLs, and a level of mostly-generic clock generators sourcing from
the PLL channels.  Most other hardware components source from the
clock generators, but a few (like the ARM or HDMI) will source from
the PLL dividers directly.

Required properties:
- compatible:	Should be "brcm,bcm2835-cprman"
- #clock-cells:	Should be <1>. The permitted clock-specifier values can be
		  found in include/dt-bindings/clock/bcm2835.h
- reg:		Specifies base physical address and size of the registers
- clocks:	phandles to the parent clocks used as input to the module, in
		  the following order:

		  - External oscillator
		  - DSI0 byte clock
		  - DSI0 DDR2 clock
		  - DSI0 DDR clock
		  - DSI1 byte clock
		  - DSI1 DDR2 clock
		  - DSI1 DDR clock

		  Only external oscillator is required.  The DSI clocks may
		  not be present, in which case their children will be
		  unusable.

Example:

	clk_osc: clock@3 {
		compatible = "fixed-clock";
		reg = <3>;
		#clock-cells = <0>;
		clock-output-names = "osc";
		clock-frequency = <19200000>;
	};

	clocks: cprman@7e101000 {
		compatible = "brcm,bcm2835-cprman";
		#clock-cells = <1>;
		reg = <0x7e101000 0x2000>;
		clocks = <&clk_osc>;
	};

	i2c0: i2c@7e205000 {
		compatible = "brcm,bcm2835-i2c";
		reg = <0x7e205000 0x1000>;
		interrupts = <2 21>;
		clocks = <&clocks BCM2835_CLOCK_VPU>;
		#address-cells = <1>;
		#size-cells = <0>;
	};