Loading...
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 114 115 116 117 118 119 120 121 122 123 124 125 126 127 128 129 130 131 132 133 134 135 136 137 138 139 140 141 142 143 144 145 146 147 148 149 150 151 152 153 154 155 156 157 158 159 160 161 162 163 164 165 166 167 168 169 170 171 172 173 174 175 176 177 178 179 180 181 182 183 184 185 186 187 188 189 190 191 192 193 194 195 196 197 198 199 200 201 202 203 204 205 206 207 208 209 210 211 212 213 214 215 216 217 218 219 220 221 222 223 224 225 226 227 228 229 230 231 232 233 234 235 236 237 238 239 240 241 242 243 244 245 246 247 248 249 250 251 252 253 254 255 256 257 | /* * Driver for ICPlus PHYs * * Copyright (c) 2007 Freescale Semiconductor, Inc. * * This program is free software; you can redistribute it and/or modify it * under the terms of the GNU General Public License as published by the * Free Software Foundation; either version 2 of the License, or (at your * option) any later version. * */ #include <linux/kernel.h> #include <linux/string.h> #include <linux/errno.h> #include <linux/unistd.h> #include <linux/interrupt.h> #include <linux/init.h> #include <linux/delay.h> #include <linux/netdevice.h> #include <linux/etherdevice.h> #include <linux/skbuff.h> #include <linux/spinlock.h> #include <linux/mm.h> #include <linux/module.h> #include <linux/mii.h> #include <linux/ethtool.h> #include <linux/phy.h> #include <asm/io.h> #include <asm/irq.h> #include <linux/uaccess.h> MODULE_DESCRIPTION("ICPlus IP175C/IP101A/IP101G/IC1001 PHY drivers"); MODULE_AUTHOR("Michael Barkowski"); MODULE_LICENSE("GPL"); /* IP101A/G - IP1001 */ #define IP10XX_SPEC_CTRL_STATUS 16 /* Spec. Control Register */ #define IP1001_RXPHASE_SEL (1<<0) /* Add delay on RX_CLK */ #define IP1001_TXPHASE_SEL (1<<1) /* Add delay on TX_CLK */ #define IP1001_SPEC_CTRL_STATUS_2 20 /* IP1001 Spec. Control Reg 2 */ #define IP1001_APS_ON 11 /* IP1001 APS Mode bit */ #define IP101A_G_APS_ON 2 /* IP101A/G APS Mode bit */ #define IP101A_G_IRQ_CONF_STATUS 0x11 /* Conf Info IRQ & Status Reg */ #define IP101A_G_IRQ_PIN_USED (1<<15) /* INTR pin used */ #define IP101A_G_IRQ_DEFAULT IP101A_G_IRQ_PIN_USED static int ip175c_config_init(struct phy_device *phydev) { int err, i; static int full_reset_performed; if (full_reset_performed == 0) { /* master reset */ err = mdiobus_write(phydev->mdio.bus, 30, 0, 0x175c); if (err < 0) return err; /* ensure no bus delays overlap reset period */ err = mdiobus_read(phydev->mdio.bus, 30, 0); /* data sheet specifies reset period is 2 msec */ mdelay(2); /* enable IP175C mode */ err = mdiobus_write(phydev->mdio.bus, 29, 31, 0x175c); if (err < 0) return err; /* Set MII0 speed and duplex (in PHY mode) */ err = mdiobus_write(phydev->mdio.bus, 29, 22, 0x420); if (err < 0) return err; /* reset switch ports */ for (i = 0; i < 5; i++) { err = mdiobus_write(phydev->mdio.bus, i, MII_BMCR, BMCR_RESET); if (err < 0) return err; } for (i = 0; i < 5; i++) err = mdiobus_read(phydev->mdio.bus, i, MII_BMCR); mdelay(2); full_reset_performed = 1; } if (phydev->mdio.addr != 4) { phydev->state = PHY_RUNNING; phydev->speed = SPEED_100; phydev->duplex = DUPLEX_FULL; phydev->link = 1; netif_carrier_on(phydev->attached_dev); } return 0; } static int ip1xx_reset(struct phy_device *phydev) { int bmcr; /* Software Reset PHY */ bmcr = phy_read(phydev, MII_BMCR); if (bmcr < 0) return bmcr; bmcr |= BMCR_RESET; bmcr = phy_write(phydev, MII_BMCR, bmcr); if (bmcr < 0) return bmcr; do { bmcr = phy_read(phydev, MII_BMCR); if (bmcr < 0) return bmcr; } while (bmcr & BMCR_RESET); return 0; } static int ip1001_config_init(struct phy_device *phydev) { int c; c = ip1xx_reset(phydev); if (c < 0) return c; /* Enable Auto Power Saving mode */ c = phy_read(phydev, IP1001_SPEC_CTRL_STATUS_2); if (c < 0) return c; c |= IP1001_APS_ON; c = phy_write(phydev, IP1001_SPEC_CTRL_STATUS_2, c); if (c < 0) return c; if (phy_interface_is_rgmii(phydev)) { c = phy_read(phydev, IP10XX_SPEC_CTRL_STATUS); if (c < 0) return c; c &= ~(IP1001_RXPHASE_SEL | IP1001_TXPHASE_SEL); if (phydev->interface == PHY_INTERFACE_MODE_RGMII_ID) c |= (IP1001_RXPHASE_SEL | IP1001_TXPHASE_SEL); else if (phydev->interface == PHY_INTERFACE_MODE_RGMII_RXID) c |= IP1001_RXPHASE_SEL; else if (phydev->interface == PHY_INTERFACE_MODE_RGMII_TXID) c |= IP1001_TXPHASE_SEL; c = phy_write(phydev, IP10XX_SPEC_CTRL_STATUS, c); if (c < 0) return c; } return 0; } static int ip101a_g_config_init(struct phy_device *phydev) { int c; c = ip1xx_reset(phydev); if (c < 0) return c; /* INTR pin used: speed/link/duplex will cause an interrupt */ c = phy_write(phydev, IP101A_G_IRQ_CONF_STATUS, IP101A_G_IRQ_DEFAULT); if (c < 0) return c; /* Enable Auto Power Saving mode */ c = phy_read(phydev, IP10XX_SPEC_CTRL_STATUS); c |= IP101A_G_APS_ON; return phy_write(phydev, IP10XX_SPEC_CTRL_STATUS, c); } static int ip175c_read_status(struct phy_device *phydev) { if (phydev->mdio.addr == 4) /* WAN port */ genphy_read_status(phydev); else /* Don't need to read status for switch ports */ phydev->irq = PHY_IGNORE_INTERRUPT; return 0; } static int ip175c_config_aneg(struct phy_device *phydev) { if (phydev->mdio.addr == 4) /* WAN port */ genphy_config_aneg(phydev); return 0; } static int ip101a_g_ack_interrupt(struct phy_device *phydev) { int err = phy_read(phydev, IP101A_G_IRQ_CONF_STATUS); if (err < 0) return err; return 0; } static struct phy_driver icplus_driver[] = { { .phy_id = 0x02430d80, .name = "ICPlus IP175C", .phy_id_mask = 0x0ffffff0, .features = PHY_BASIC_FEATURES, .config_init = &ip175c_config_init, .config_aneg = &ip175c_config_aneg, .read_status = &ip175c_read_status, .suspend = genphy_suspend, .resume = genphy_resume, }, { .phy_id = 0x02430d90, .name = "ICPlus IP1001", .phy_id_mask = 0x0ffffff0, .features = PHY_GBIT_FEATURES, .config_init = &ip1001_config_init, .config_aneg = &genphy_config_aneg, .read_status = &genphy_read_status, .suspend = genphy_suspend, .resume = genphy_resume, }, { .phy_id = 0x02430c54, .name = "ICPlus IP101A/G", .phy_id_mask = 0x0ffffff0, .features = PHY_BASIC_FEATURES, .flags = PHY_HAS_INTERRUPT, .ack_interrupt = ip101a_g_ack_interrupt, .config_init = &ip101a_g_config_init, .config_aneg = &genphy_config_aneg, .read_status = &genphy_read_status, .suspend = genphy_suspend, .resume = genphy_resume, } }; module_phy_driver(icplus_driver); static struct mdio_device_id __maybe_unused icplus_tbl[] = { { 0x02430d80, 0x0ffffff0 }, { 0x02430d90, 0x0ffffff0 }, { 0x02430c54, 0x0ffffff0 }, { } }; MODULE_DEVICE_TABLE(mdio, icplus_tbl); |