Loading...
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 114 115 116 117 118 119 120 121 122 123 124 125 126 127 128 129 130 131 132 133 134 135 136 137 138 139 140 141 142 143 144 145 146 147 148 149 150 151 152 153 154 155 156 157 158 159 160 161 162 163 164 165 166 167 168 169 170 171 172 173 174 175 176 177 178 179 180 181 182 183 184 185 186 187 188 189 190 191 192 193 194 195 196 197 198 199 200 201 202 203 204 205 206 207 208 209 210 211 212 213 214 215 216 217 218 219 220 221 222 223 224 225 226 227 228 229 230 231 232 233 234 235 236 237 238 239 240 241 242 243 244 245 246 247 248 249 250 251 252 253 254 255 256 257 258 259 260 261 262 263 264 265 266 267 268 269 270 271 272 273 274 | // SPDX-License-Identifier: GPL-2.0 /* * Driver for EETI eGalax Multiple Touch Controller * * Copyright (C) 2011 Freescale Semiconductor, Inc. * * based on max11801_ts.c */ /* EETI eGalax serial touch screen controller is a I2C based multiple * touch screen controller, it supports 5 point multiple touch. */ /* TODO: - auto idle mode support */ #include <linux/err.h> #include <linux/module.h> #include <linux/i2c.h> #include <linux/interrupt.h> #include <linux/input.h> #include <linux/irq.h> #include <linux/gpio/consumer.h> #include <linux/delay.h> #include <linux/slab.h> #include <linux/bitops.h> #include <linux/input/mt.h> /* * Mouse Mode: some panel may configure the controller to mouse mode, * which can only report one point at a given time. * This driver will ignore events in this mode. */ #define REPORT_MODE_MOUSE 0x1 /* * Vendor Mode: this mode is used to transfer some vendor specific * messages. * This driver will ignore events in this mode. */ #define REPORT_MODE_VENDOR 0x3 /* Multiple Touch Mode */ #define REPORT_MODE_MTTOUCH 0x4 #define MAX_SUPPORT_POINTS 5 #define EVENT_VALID_OFFSET 7 #define EVENT_VALID_MASK (0x1 << EVENT_VALID_OFFSET) #define EVENT_ID_OFFSET 2 #define EVENT_ID_MASK (0xf << EVENT_ID_OFFSET) #define EVENT_IN_RANGE (0x1 << 1) #define EVENT_DOWN_UP (0X1 << 0) #define MAX_I2C_DATA_LEN 10 #define EGALAX_MAX_X 32760 #define EGALAX_MAX_Y 32760 #define EGALAX_MAX_TRIES 100 struct egalax_ts { struct i2c_client *client; struct input_dev *input_dev; }; static irqreturn_t egalax_ts_interrupt(int irq, void *dev_id) { struct egalax_ts *ts = dev_id; struct input_dev *input_dev = ts->input_dev; struct i2c_client *client = ts->client; u8 buf[MAX_I2C_DATA_LEN]; int id, ret, x, y, z; int tries = 0; bool down, valid; u8 state; do { ret = i2c_master_recv(client, buf, MAX_I2C_DATA_LEN); } while (ret == -EAGAIN && tries++ < EGALAX_MAX_TRIES); if (ret < 0) return IRQ_HANDLED; if (buf[0] != REPORT_MODE_MTTOUCH) { /* ignore mouse events and vendor events */ return IRQ_HANDLED; } state = buf[1]; x = (buf[3] << 8) | buf[2]; y = (buf[5] << 8) | buf[4]; z = (buf[7] << 8) | buf[6]; valid = state & EVENT_VALID_MASK; id = (state & EVENT_ID_MASK) >> EVENT_ID_OFFSET; down = state & EVENT_DOWN_UP; if (!valid || id > MAX_SUPPORT_POINTS) { dev_dbg(&client->dev, "point invalid\n"); return IRQ_HANDLED; } input_mt_slot(input_dev, id); input_mt_report_slot_state(input_dev, MT_TOOL_FINGER, down); dev_dbg(&client->dev, "%s id:%d x:%d y:%d z:%d", down ? "down" : "up", id, x, y, z); if (down) { input_report_abs(input_dev, ABS_MT_POSITION_X, x); input_report_abs(input_dev, ABS_MT_POSITION_Y, y); input_report_abs(input_dev, ABS_MT_PRESSURE, z); } input_mt_report_pointer_emulation(input_dev, true); input_sync(input_dev); return IRQ_HANDLED; } /* wake up controller by an falling edge of interrupt gpio. */ static int egalax_wake_up_device(struct i2c_client *client) { struct gpio_desc *gpio; int ret; /* wake up controller via an falling edge on IRQ gpio. */ gpio = gpiod_get(&client->dev, "wakeup", GPIOD_OUT_HIGH); ret = PTR_ERR_OR_ZERO(gpio); if (ret) { if (ret != -EPROBE_DEFER) dev_err(&client->dev, "failed to request wakeup gpio, cannot wake up controller: %d\n", ret); return ret; } /* release the line */ gpiod_set_value_cansleep(gpio, 0); /* controller should be woken up, return irq. */ gpiod_direction_input(gpio); gpiod_put(gpio); return 0; } static int egalax_firmware_version(struct i2c_client *client) { static const u8 cmd[MAX_I2C_DATA_LEN] = { 0x03, 0x03, 0xa, 0x01, 0x41 }; int ret; ret = i2c_master_send(client, cmd, MAX_I2C_DATA_LEN); if (ret < 0) return ret; return 0; } static int egalax_ts_probe(struct i2c_client *client) { struct egalax_ts *ts; struct input_dev *input_dev; int error; ts = devm_kzalloc(&client->dev, sizeof(struct egalax_ts), GFP_KERNEL); if (!ts) { dev_err(&client->dev, "Failed to allocate memory\n"); return -ENOMEM; } input_dev = devm_input_allocate_device(&client->dev); if (!input_dev) { dev_err(&client->dev, "Failed to allocate memory\n"); return -ENOMEM; } ts->client = client; ts->input_dev = input_dev; /* controller may be in sleep, wake it up. */ error = egalax_wake_up_device(client); if (error) return error; error = egalax_firmware_version(client); if (error < 0) { dev_err(&client->dev, "Failed to read firmware version\n"); return error; } input_dev->name = "EETI eGalax Touch Screen"; input_dev->id.bustype = BUS_I2C; __set_bit(EV_ABS, input_dev->evbit); __set_bit(EV_KEY, input_dev->evbit); __set_bit(BTN_TOUCH, input_dev->keybit); input_set_abs_params(input_dev, ABS_X, 0, EGALAX_MAX_X, 0, 0); input_set_abs_params(input_dev, ABS_Y, 0, EGALAX_MAX_Y, 0, 0); input_set_abs_params(input_dev, ABS_MT_POSITION_X, 0, EGALAX_MAX_X, 0, 0); input_set_abs_params(input_dev, ABS_MT_POSITION_Y, 0, EGALAX_MAX_Y, 0, 0); input_mt_init_slots(input_dev, MAX_SUPPORT_POINTS, 0); error = devm_request_threaded_irq(&client->dev, client->irq, NULL, egalax_ts_interrupt, IRQF_ONESHOT, "egalax_ts", ts); if (error < 0) { dev_err(&client->dev, "Failed to register interrupt\n"); return error; } error = input_register_device(ts->input_dev); if (error) return error; return 0; } static const struct i2c_device_id egalax_ts_id[] = { { "egalax_ts", 0 }, { } }; MODULE_DEVICE_TABLE(i2c, egalax_ts_id); static int egalax_ts_suspend(struct device *dev) { static const u8 suspend_cmd[MAX_I2C_DATA_LEN] = { 0x3, 0x6, 0xa, 0x3, 0x36, 0x3f, 0x2, 0, 0, 0 }; struct i2c_client *client = to_i2c_client(dev); int ret; if (device_may_wakeup(dev)) return enable_irq_wake(client->irq); ret = i2c_master_send(client, suspend_cmd, MAX_I2C_DATA_LEN); return ret > 0 ? 0 : ret; } static int egalax_ts_resume(struct device *dev) { struct i2c_client *client = to_i2c_client(dev); if (device_may_wakeup(dev)) return disable_irq_wake(client->irq); return egalax_wake_up_device(client); } static DEFINE_SIMPLE_DEV_PM_OPS(egalax_ts_pm_ops, egalax_ts_suspend, egalax_ts_resume); static const struct of_device_id egalax_ts_dt_ids[] = { { .compatible = "eeti,egalax_ts" }, { /* sentinel */ } }; MODULE_DEVICE_TABLE(of, egalax_ts_dt_ids); static struct i2c_driver egalax_ts_driver = { .driver = { .name = "egalax_ts", .pm = pm_sleep_ptr(&egalax_ts_pm_ops), .of_match_table = egalax_ts_dt_ids, }, .id_table = egalax_ts_id, .probe = egalax_ts_probe, }; module_i2c_driver(egalax_ts_driver); MODULE_AUTHOR("Freescale Semiconductor, Inc."); MODULE_DESCRIPTION("Touchscreen driver for EETI eGalax touch controller"); MODULE_LICENSE("GPL"); |