GPIO Driver for XRA1403 16-BIT GPIO Expander With Reset Input from EXAR

The XRA1403 is an 16-bit GPIO expander with an SPI interface. Features available:
	- Individually programmable inputs:
		- Internal pull-up resistors
		- Polarity inversion
		- Individual interrupt enable
		- Rising edge and/or Falling edge interrupt
		- Input filter
	- Individually programmable outputs
		- Output Level Control
		- Output Three-State Control

Properties
----------
Check documentation for SPI and GPIO controllers regarding properties needed to configure the node.

	- compatible = "exar,xra1403".
	- reg - SPI id of the device.
	- gpio-controller - marks the node as gpio.
	- #gpio-cells - should be two where the first cell is the pin number
		and the second one is used for optional parameters.

Optional properties:
-------------------
	- reset-gpios: in case available used to control the device reset line.
	- interrupt-controller - marks the node as interrupt controller.
	- #interrupt-cells - should be two and represents the number of cells
		needed to encode interrupt source.

Example
--------

	gpioxra0: gpio@2 {
		compatible = "exar,xra1403";
		reg = <2>;

		gpio-controller;
		#gpio-cells = <2>;

		interrupt-controller;
		#interrupt-cells = <2>;

		reset-gpios = <&gpio3 6 GPIO_ACTIVE_LOW>;
		spi-max-frequency = <1000000>;
	};