Loading...
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 114 115 116 117 | /* SPDX-License-Identifier: GPL-2.0 OR BSD-3-Clause */ /* * Copyright (C) 2012-2014, 2018-2019 Intel Corporation * Copyright (C) 2013-2015 Intel Mobile Communications GmbH * Copyright (C) 2016-2017 Intel Deutschland GmbH */ #ifndef __iwl_fw_api_config_h__ #define __iwl_fw_api_config_h__ /* * struct iwl_dqa_enable_cmd * @cmd_queue: the TXQ number of the command queue */ struct iwl_dqa_enable_cmd { __le32 cmd_queue; } __packed; /* DQA_CONTROL_CMD_API_S_VER_1 */ /* * struct iwl_tx_ant_cfg_cmd * @valid: valid antenna configuration */ struct iwl_tx_ant_cfg_cmd { __le32 valid; } __packed; /** * struct iwl_calib_ctrl - Calibration control struct. * Sent as part of the phy configuration command. * @flow_trigger: bitmap for which calibrations to perform according to * flow triggers, using &enum iwl_calib_cfg * @event_trigger: bitmap for which calibrations to perform according to * event triggers, using &enum iwl_calib_cfg */ struct iwl_calib_ctrl { __le32 flow_trigger; __le32 event_trigger; } __packed; /* This enum defines the bitmap of various calibrations to enable in both * init ucode and runtime ucode through CALIBRATION_CFG_CMD. */ enum iwl_calib_cfg { IWL_CALIB_CFG_XTAL_IDX = BIT(0), IWL_CALIB_CFG_TEMPERATURE_IDX = BIT(1), IWL_CALIB_CFG_VOLTAGE_READ_IDX = BIT(2), IWL_CALIB_CFG_PAPD_IDX = BIT(3), IWL_CALIB_CFG_TX_PWR_IDX = BIT(4), IWL_CALIB_CFG_DC_IDX = BIT(5), IWL_CALIB_CFG_BB_FILTER_IDX = BIT(6), IWL_CALIB_CFG_LO_LEAKAGE_IDX = BIT(7), IWL_CALIB_CFG_TX_IQ_IDX = BIT(8), IWL_CALIB_CFG_TX_IQ_SKEW_IDX = BIT(9), IWL_CALIB_CFG_RX_IQ_IDX = BIT(10), IWL_CALIB_CFG_RX_IQ_SKEW_IDX = BIT(11), IWL_CALIB_CFG_SENSITIVITY_IDX = BIT(12), IWL_CALIB_CFG_CHAIN_NOISE_IDX = BIT(13), IWL_CALIB_CFG_DISCONNECTED_ANT_IDX = BIT(14), IWL_CALIB_CFG_ANT_COUPLING_IDX = BIT(15), IWL_CALIB_CFG_DAC_IDX = BIT(16), IWL_CALIB_CFG_ABS_IDX = BIT(17), IWL_CALIB_CFG_AGC_IDX = BIT(18), }; /** * struct iwl_phy_specific_cfg - specific PHY filter configuration * * Sent as part of the phy configuration command (v3) to configure specific FW * defined PHY filters that can be applied to each antenna. * * @filter_cfg_chain_a: filter config id for LMAC1 chain A * @filter_cfg_chain_b: filter config id for LMAC1 chain B * @filter_cfg_chain_c: filter config id for LMAC2 chain A * @filter_cfg_chain_d: filter config id for LMAC2 chain B * values: 0 - no filter; 0xffffffff - reserved; otherwise - filter id */ struct iwl_phy_specific_cfg { __le32 filter_cfg_chain_a; __le32 filter_cfg_chain_b; __le32 filter_cfg_chain_c; __le32 filter_cfg_chain_d; } __packed; /* PHY_SPECIFIC_CONFIGURATION_API_VER_1*/ /** * struct iwl_phy_cfg_cmd - Phy configuration command * * @phy_cfg: PHY configuration value, uses &enum iwl_fw_phy_cfg * @calib_control: calibration control data */ struct iwl_phy_cfg_cmd_v1 { __le32 phy_cfg; struct iwl_calib_ctrl calib_control; } __packed; /** * struct iwl_phy_cfg_cmd_v3 - Phy configuration command (v3) * * @phy_cfg: PHY configuration value, uses &enum iwl_fw_phy_cfg * @calib_control: calibration control data * @phy_specific_cfg: configure predefined PHY filters */ struct iwl_phy_cfg_cmd_v3 { __le32 phy_cfg; struct iwl_calib_ctrl calib_control; struct iwl_phy_specific_cfg phy_specific_cfg; } __packed; /* PHY_CONFIGURATION_CMD_API_S_VER_3 */ /* * enum iwl_dc2dc_config_id - flag ids * * Ids of dc2dc configuration flags */ enum iwl_dc2dc_config_id { DCDC_LOW_POWER_MODE_MSK_SET = 0x1, /* not used */ DCDC_FREQ_TUNE_SET = 0x2, }; /* MARKER_ID_API_E_VER_1 */ #endif /* __iwl_fw_api_config_h__ */ |